3Com NBX 100 Administrator's Manual page 221

To modify a BRI group:
1 On the Digital Line Cards tab, from the Select Device Type drop-down list,
select ISDN BRI Group List.
2 Click Apply.
3 Select the group that you want to modify.
4 Click Modify. The Modify Group dialog box appears.
5 Make the changes that you want to the group parameters. See
6 Enable the On Line check box to bring the group on line. Click Apply for
the changes to go into effect and then click OK.
Table 44 Group Parameters
Parameter
Group Name
Channel Protocol
E&M Direction
Start Type
Digit Collection
Called Party Digits
Calling Party Digits N/A
Auto Extension
Trunk to Trunk
Timer Values
New Value
Changing BRI Group Membership
You may want to change the channel membership in a group to
accommodate changing needs.
To change group membership:
1 On the Digital Line Cards tab, from the Select Device Type drop-down list,
select ISDN BRI Group List and then click Apply.
2 Select the group for which you want to change membership.
Configuring and Managing BRI-ST Digital Line Cards
ISDN BRI Options
A name to help you to identify this group in a list.
N/A
N/A
N/A
N/A
N/A
The Auto Extension number to handle this group for any of the
Business Hours. Extension 500 is the Auto Attendant.
The Unrestricted setting enables and the Restricted setting
disables the transfer of incoming calls to another line card port.
For example, enable Trunk to Trunk transfers if you plan to
connect a Voice Over IP (VOIP) gateway to a line card port,
permit callers to use the system to access the telephone system
from a remote location, or use it to make CO calls.
N/A
N/A
221
Table 44.