Configuration And Status Reports - 3Com NBX 100 Administrator's Manual

366 C 10: T
HAPTER ROUBLESHOOTING
Configuration and
Status Reports
Table 79 Digital Line Card Status Lights (continued)
Status Light Purpose
RA (Remote Alarm) On: Indicates a Yellow Alarm state on the card.
To confirm that the Yellow Alarm state exists:
1 Log on to NBX NetSet using the administrator login ID and
2 In the NBX NetSet - Main Menu window, click Device
3 Click the Digital Line Cards tab.
4 In the Select Device Type drop-down list, if you are using a
5 Click Apply.
6 Select the span you want and click Status. The words
NOTE: This light is used only on the T1 Digital Line Card.
LB (Loop Back) On: Indicates that the card is in loop-back testing mode.
NOTE: This light is not used to indicate any of the Red, Blue,
or Yellow alarms.
You can obtain the status of all Digital Line Cards in the NBX system with
either of these two methods:
Select NBX NetSet > Device Configuration > Digital Line Cards and:
Click Config & Status Report. The formatted report appears on the
■
screen with headings shown in a larger font.
Click Export Report. The unformatted report appears on the screen. To
■
save the report as an ASCII text file, select Save as from the File menu
of your browser.
Table 80 describes in alphabetical order (not the order of appearance) the
headings in the Configuration and Status Report.
Table 80 Configuration and Status Report Headings
Heading Description
#Chs Number of channels.
#Dsp Number of digital signal processors.
#OffCh Number of channels in the offline state.
password.
Configuration.
T1 Digital Line Card, select T1 Span List or, if you are using
an E1 Digital Line Card, select ISDN PRI Span List.
Yellow Alarm appear in the Status field.