3Com NBX 100 Administrator's Manual page 369

Table 80 Configuration and Status Report Headings (continued)
Heading Description
OffHk Min The minimum time an analog telephone, connected to an
Analog Terminal Card, must be off hook for the NBX system to
recognize that the telephone has been picked up.
On Line One possible status of a channel.
Prepend Prefix Full text: Prepend prefix to Calling Party Number in Setup
Indication.
Either enabled or disabled. National and international prefixes
can be added for outgoing calls. The prefix is for situations
where the telephone company equipment requires special
configuration on the NBX system.
Protocol A signaling method used to make calls.
Recv. Timer Full Text: Overlap Receiving timer (T302).
PRI span only. An advanced configuration setting for situations
where the telephone company equipment requires special
configuration on the NBX system.
Release Complete Full Text: Send "Release Complete" if incoming call is from
incompatible equipment.
Either enabled or disabled. An advanced configuration setting
for situations where the telephone company equipment
requires special configuration on the NBX system.
RxWnkMax The maximum duration of a received Wink signal.
RxWnkMin The minimum duration of a received Wink signal.
SpId Span ID.
SpNo Span number.
Sending Complete Full Text: Send "Sending Complete IE" in Setup Request
IE (Information Element) refers to the data fields within an
ISDN layer 3 message. An advanced configuration setting for
situations where the telephone company equipment requires
special configuration on the NBX system.
Span MAC Address MAC address assigned to this span.
Span Name Name of span.
SpanNo Identifying number for a span.
Start Type Mechanism used to indicate start of a call.
Status Status of a channel, span, card. Values: Online, Idle, Unknown.
Default: Online
System-level Troubleshooting 369