Call Park / Call Park Answer - Comdial DX-80 Installation And Maintenance Manual

Note: Changes made via PC-DBA are not updated to the DX-80 system memory until a "SEND" function
has been performed. Please refer to the Programming section of this manual to learn more about this
procedure.

Call Park / Call Park Answer

This feature allows you to "Park" a call at any extension. It also is used to retrieve a parked call from any extension.
Calls are parked and retrieved by dialing the Call Park code (Feature 73) followed by the extension number where the
call is to be/has been parked.
Call Park is very similar to Transfer except there is no ringing at the park destination.
The DX-80 Call Park method eliminates multiple call park codes by using the same code followed by the user
extension number for multiple calls parked to one extension number.
Related Features
Flexible Feature Button Programming
Transfer (Idle/Busy Recall Timers)
Related Programming
Extension - Tenant Group, Paging Group, Paging Allow, Pick Up Groups
Call Handling - Hold Recall, Hold Abandon Time, (Park Remind)
Operation – Park Call
1. While connected to a CO Line call, press
code.
2. Dial the extension number where this call is to be parked, or press the DSS button of the extension where
this call is to be parked.
3. The CO Line call is parked at that extension.
4. Go on-hook or proceed with other system functions.
Note: Multiple calls may be parked on one extension.
Operation – Call Park Answer
1. While the extension is idle, press
2. Dial the extension number where this call is to be parked, or press the DSS button of the extension where
this call is to be parked.
3. You are connected to the call.
Analog Ports (Single Line Telephones)
#73
1. Dial .
2. Dial the extension number where the call is parked.
Conditions
a) Each telephone/extension has one personal extension number used to park one CO line call.
b) From your telephone you can park a call at any assigned and installed extension number.
c) The Call Park feature code may be programmed on any programmable feature button.
d) Calls can be retrieved from any extension.
e) CO lines that have been parked are on Transfer Hold at the extension that where the call was parked and on
I-Hold at the extension that parked the call.
P7290 IMM
DX-80 I M
NSTALLATION AND AINTENANCE
!73
!73
or press a button programmed for this Call Park code.
3-53
M
ANUAL
Pick up Groups
or press a button programmed for this Call Park
!73