Fns Adjusting The Paper Exit-Opening Lower Guide Plate (Fs-111) - Konica Minolta 7155 Service Manual

OTHER ADJUSTMENT
b. Adjustment
Step
Remove the 2 set screws holding the
solenoid bracket in place, and remove
the solenoid together with the bracket.
1
Loosen the 2 screws holding the sole-
noid to the bracket, and adjust the posi-
tion of solenoid.
2
Retighten the 2 solenoid screws, then
replace the solenoid and bracket into
3
their original position and screw in the 2
bracket screws.
Reassemble in the opposite sequence
4
to removal.
MODEL
7155/7165/7255/7272 SERVICE MANUAL
Operation
Solenoid Bracket
Screws
7272fs1037
Solenoid Bracket
Screws
7272fs1038
MANUAL REVISED EDITION
[42] FNS Adjusting the Paper Exit-Open-
4
ing Lower Guide Plate (FS-111)
1. Tool
• Screwdriver (Phillips)
• Scale
2. Adjustment method
a. Preparation
Step
Remove the following parts.
• Rear cover
1
• Top cover
With SD4 (paper exit-opening solenoid)
OFF, confirm that the paper exit-opening
lower guide plate is a sufficient distance
(distance A) higher than the sponge roll-
ers.
Spec value: A = 1.5mm and greater
2
A=1.5mm and greater
Sponge Roller
DATE
4 Dec. 2003
Operation
Lower Guide Plate
7272fs1039
PAGE METHOD
1-146 ADDITION