Removing And Reinstalling The Fixing Input Gear - Konica Minolta 7155 Service Manual

DRIVE SECTION
(8) Remove three screws and remove the two fly-
wheels.
(9) Remove the connector (CN301).
(10) Remove four screws and remove the drum motor
(M2).
Drum motor (M2)
Screws (4)
(11) Reinstall the above parts following the removal
steps in reverse.
[2] Removing and Reinstalling the Fixing
Flywheels (2)
Screws (3)
Connector (CN301)
3-B-2 3-B-4
Input Gear
Caution:
Be sure the power cord has been
unplugged from the wall outlet.
a. Procedure
(1) Open the image control bard mounting board.
(2) Remove six screws and remove the fixing motor
cover.
(3) Pull out the connector (CN304), remove four
screws to remove the fixing motor assembly.
Caution: Hold the fixing motor assembly with
your hand because it is connected to
the main body with cable.
Screws (4)
Fixing motor cover
(4) Remove two screws to remove the fixing input
gear holder.
(5) Pull out the fixing input gear from the shaft.
Fixing input gear
(6) Reinstall the above parts following the removal
steps in reverse.
Fixing motor assembly
Connector
(CN304)
Screws (6)
Fixing input gear holder
Screws (2)