Fns Adjusting The Mount Location Of The Paper Exit Arm (Fs-111) - Konica Minolta 7155 Service Manual

Step
Hold down the paper exit-opening lower
guide plate with your hand so that the
paper exit roller makes contact, and
check that the remaining stroke for sole-
noid SD4 (distance B) is within spec.
Spec value: B = 2.5±0.5mm
SD4 (Paper
Exit Opening)
3
If either measurement is out of spec,
carry out adjustment as described
4
below.
b. Adjustment
Step
Loosen the 2 set screws holding the
solenoid bracket in place, and adjust the
position of the bracket so that distances
A and B are within spec.
1
Retighten the 2 bracket set screws.
2
Reassemble in the reverse sequence to
3
removal.
MODEL
7155/7165/7255/7272 SERVICE MANUAL
Operation
B=2.5 0.5mm
Paper Exit
Lower
Guide Plate
7272fs1040
Operation
Solenoid Bracket
Screws
7272fs1041
MANUAL REVISED EDITION
[43] FNS Adjusting the Mount Location of
4
the Paper Exit Arm (FS-111)
1. Tool
• Screwdriver (Phillips)
2. Adjustment method
a. Preparation
Step
PRemove the screw to remove the belt
1
detection gear.
When the stacker paper exit arm is at the
position shown below, secure the belt
detection gear with a screw with the
actuator end face of the belt detection
gear aligned with the bottom of the
square hole.
Actuator end face
Belt detection
2
Stacker paper exit arm
DATE
4
Dec. 2003
OTHER ADJUSTMENT
Operation
Screw
Bottom of square hole
7272fs1042
PAGE METHOD
1-147 ADDITION