Fns Adjusting The Paper-Path Switching Gate (Fs-111) - Konica Minolta 7155 Service Manual

OTHER ADJUSTMENT
Step
With SD2 (sub-tray paper exit) OFF,
measure the gap between the sub-tray
gate and the guide plate (indicated by A
3
in the illustration).
Spec value for gap: A = 4 ±0.5mm.
With SD2 ON, measure the gap between
the solenoid plunger and the bracket
stopper (indicated by B in the illustra-
tion).
Spec value for gap: B = 5 ±0.5mm.
SD2
(Sub-tray
Paper Exit)
4
Sub-tray Gate
If either gap is out of spec, carry out
5
adjustment as described below.
b. Adjustment
Step
Loosen the 2 set screws holding the
solenoid in place, and move the solenoid
as necessary to adjust.
Screws
1
Solenoid
Retighten the screws.
2
Reinstall in opposite sequence to
3
removal.
MODEL
7155/7165/7255/7272 SERVICE MANUAL
Operation
7272fs1021
Operation
7272fs1022
MANUAL REVISED EDITION
[37] FNS Adjusting the Paper-Path
4
Switching Gate (FS-111)
1. Tool
• Screwdriver (Phillips)
• Scale
2. Adjustment method
a. Preparation
Step
Remove the following parts.
• Rear cover
1
• Top cover
Remove the 2 set screws holding the
FNS CB (FNS control board) in place.
Remove the FNS CB together with its
bracket.
FNS CB (Finisher Control Board)
Bracket
2
DATE
Dec. 2003
4
Operation
Screws
7272fs1023
PAGE METHOD
1-140 ADDITION