Fns Adjusting The Stapling Position (Flat Stapling) (Fs-110/210) - Konica Minolta 7155 Service Manual

OTHER ADJUSTMENT
Step
Load paper sized 8.5x11R or larger, put
the paper against the alignment plate /U
(rear) and the alignment plate /L (rear)
and check whether the paper is plumb.
In addition, check whether the distances
A for the alignment plate /L are within
specification.
Spec values: A=340.6
6
If they are out of spec, perform the fol-
7
lowing adjustment:
b. Adjustment
Step
Loosen the two screws and perform the
adjustment so that the mount location of
the alignment plate /L are within specifi-
cation.
Alignment plate /L
1
MODEL
MODEL
7155/7165/7255/7272 7155/7165 SERVICE HANDBOOK SERVICE MANUAL
Operation
+0
mm (within)
- 0.5
Paper
Alignment plate /U
(rear)
Rear panel
surface
Alignment
plate /L
Operation
Alignment plate /L
Screw
Screw
MANUAL REVISED EDITION
MANUAL REVISED EDITION
[19] FNS Adjusting the stapling position
4
(Flat stapling) (FS-110/210)
Caution: Do not use hands to move stapler unit
to horizontal direction.
(Otherwise the belt and the gear teeth
skipping may occur.)
1. Tool
• Screwdriver (Phillips)
• Scale
2. Adjustment method
a. Preparation
Step
Perform the following stapling actually
and check whether they are within spec-
ification. In the case of flat stapling,
check whether the paper edge is parallel
to the virtual line running between the
staplers.
One-corner stapling
1
Flat stapling
Parallel
If they are out of spec or not parallel, per-
2
form the following adjustment:
DATE
DATE
4 Dec. 2003 Apr. 2003
Operation
One-point stapling
(at rear) (at front)
PAGE METHOD
PAGE METHOD
1-120 REPLACEMENT REPLACEMENT
1-1