Fns Adjusting The Stapler Vertical Positioning (Fs-110/210) - Konica Minolta 7155 Service Manual

b. Adjustment
Step
Open the front door and pull out the
1
stacker unit.
Take off the stapler unit cover.
2
Loosen the adjustment screws for the
clincher /F and Clincher /R and perform
adjustment using marks as a guide.
Clincher /F
3
Clincher /F
Mark
Execute stapling to confirm that the sta-
4
pling is within the specification range.
MODEL
MODEL
7155/7165/7255/7272 7155/7165 SERVICE HANDBOOK SERVICE MANUAL
Operation
Clincher /R
Clincher /R
Mark
Adjustment screw
MANUAL REVISED EDITION
MANUAL REVISED EDITION
[20] FNS Adjusting the stapler vertical
4
positioning (FS-110/210)
Caution: Do not use hands to move stapler unit
to horizontal direction.
(Otherwise the belt and the gear teeth
skipping may occur.)
1. Tool
• Screwdriver (Phillips)
• Jig
2. Adjustment method
a. Preparation
Step
Execute stapling and check for buckled
staple-needles or clinching failure.
Caution: When replacing or removing a
Buckled
1
stapling
Floating
stapling
Height of
bent
staple-needle
When any defect described above can
be seen, perform the following adjust-
2
ment:
b. Adjustment
Step
Open the front door and pull out the
1
stacker unit.
Take off the stapler unit cover.
2
DATE
DATE
4
Nov. 2001 Dec. 2003
OTHER ADJUSTMENT
Operation
clincher or stapler, perform
adjustment after reinstalling.
L
L=1mm or less
L
L=0.7mm or less
Operation
PAGE METHOD
PAGE METHOD
1-121 REPLACEMENT REPLACEMENT
1-2