Fns Adjusting The Angle Of The Folding Stopper (Fs-210) - Konica Minolta 7155 Service Manual

OTHER ADJUSTMENT
b. Adjustment
Step
Make sure that the "Adjusting the mount
location of the alignment plates / U" and
1
"Adjusting the mount location of the
alignment plates / L" are finished.
Open the front door and pull out the
2
stacker unit.
Take off the stapler unit cover.
3
Loosen the three screws securing the
alignment plate and adjust it using the
mark as a guide.
Mark
4
Parallel
Mark
Mark
After the adjustment, retighten the three
screws, execute stapling, and then
5
check that the aligned position is within
the specification range.
MODEL
7155/7165 SERVICE HANDBOOK
Operation
Alignment
plate /L
Screws
Upper edge
Lower edge
MANUAL REVISED EDITION
[22] FNS Adjusting the angle of the fold-
ing stopper (FS-210)
Caution: Do not use hands to move stapler unit
to horizontal direction.
(Otherwise the belt and the gear teeth
skipping may occur.)
1. Tool
• Screwdriver (Phillips)
2. Adjustment method
a. Preparation
Step
Execute stapling using A3 paper and
check whether the fold side discrepancy
for A3 paper is within the limit.
Limit: A= within 1mm
A= within 1mm
1
If the amount of discrepancy is out of
specification, perform the following
2
adjustment:
DATE
Nov. 2001
Operation
PAGE METHOD
REPLACEMENT
1-124