Fns Adjusting The Mount Location Of The Paper Exit Arm (Fs-110/210) - Konica Minolta 7155 Service Manual

Step
Place the solenoid to its original position,
and tighten the screw securing the sole-
noid bracket at the position where the
paper exit guide makes contact with the
cushioning rubber of the paper exit guide
stay.
Caution: Make sure that the difference
in height between the paper
exit guide and the paper exit
guide stay is 1mm and
greater.
Solenoid bracket
3
Stopping
rubber
Reassemble in the opposite sequence
4
to the removal.
MODEL
7155/7165/7255/7272 SERVICE MANUAL
Operation
Screws
Paper exit
guide stay
Paper exit guide
1mm
Paper exit guide
MANUAL REVISED EDITION
[16] FNS Adjusting the mount location of
4
the paper exit arm (FS-110/210)
1. Tool
• Screwdriver (Phillips)
2. Adjustment method
a. Preparation
Step
Open the front door and pull out the
1
stacker unit.
When aligning the actuator edge of the
belt detection gear with the notch of
panel /rear, check whether the top sur-
face of paper exit belt arm is positioned
in the middle of the two marks.
Belt detection gear
2
Top surface of paper exit belt arm
Perform the adjustment if it is out of
3
spec.
DATE
4
Dec. 2003
OTHER ADJUSTMENT
Operation
Notch of panel /rear
Actuator edge
Marks
PAGE METHOD
1-117 REPLACEMENT