Fns Adjusting The Magnets On Conveyance Guide Plate C (Fs-111) - Konica Minolta 7155 Service Manual

OTHER ADJUSTMENT
Step
Adhere the magnets to conveyance
guide plate A and retighten the set
screws.
5
Reassemble in opposite sequence to
6
removal.
MODEL
7155/7165/7255/7272 SERVICE MANUAL
Operation
Magnet
(rear)
Magnet
(front)
Gear
E-ring
Conveyance
Guide Plate A
Conveyance
Guide Plate B
7272fs1016
MANUAL REVISED EDITION
[35] FNS Adjusting the Magnets on Con-
4
veyance Guide Plate C (FS-111)
1. Tool
• Screwdriver (Phillips)
2. Adjustment method
a. Preparation
Step
Open the front cover.
1
Check whether conveyance guide plate
C makes contact with the cushioning
2
rubber when the magnets are stuck to
conveyance guide plate D.
If conveyance guide plate C does not
make contact with the cushioning rub-
3
ber, remove the rear cover and carry out
adjustment as described below.
b. Adjustment
Step
Detach all FNS CB (FNS control board)
1
connectors.
Remove the 2 set screws holding the
FNS CB in place. Remove the FNS CB
together with its bracket.
FNS CB (Finisher Control Board)
Bracket
2
Loosen the 4 magnet-holding set screws
(two at the front and two at the back), and
move conveyance guide plate C all the
3
way in the direction indicated by the
arrow.
DATE
Dec. 2003
4
Operation
Operation
Screws
7272fs1017
PAGE METHOD
1-138 ADDITION