Fns Adjusting The Magnets On The By-Pass Conveyance Guide Plate (Fs-110/210) - Konica Minolta 7155 Service Manual

OTHER ADJUSTMENT
4
[12] FNS Adjusting the magnets on the by-
pass conveyance guide plate
(FS-110/210)
1. Tool
• Screwdriver (Phillips)
2. Adjustment method
a. Preparation
Step
Open the front door.
1
When the magnet on the by-pass con-
veyance guide plate is stuck to the front
panel, check whether the stopping piece
of the plate makes contact with the con-
veyance guide plate /L.
By-pass conveyance guide plate
Magnet
2
Cushioning
rubber
By-pass conveyance guide plate
Cushioning
rubber
If the stopping piece of the by-pass con-
veyance guide plate does not make con-
3
tact with the conveyance guide plate /L,
perform the following adjustment:
MODEL
7155/7165/7255/7272 SERVICE MANUAL
Operation
Conveyance guide plate /L
Front panel
Conveyance guide plate /L
Cushioning rubber
MANUAL REVISED EDITION
b. Adjustment
Step
Loosen the two screws securing the
1
magnet.
Adjust the by-pass conveyance guide
plate to the direction indicated by the
2
arrow, and press it against the convey-
ance guide plate /L.
Adhere the magnets to the front panel
and retighten the magnet securing
screws.
By-pass conveyance guide plate
Magnet
3
Close the front door.
4
DATE
Dec. 2003
4
Operation
Screws
PAGE METHOD
1-112 REPLACEMENT