Step
23
Click
to open the FIM, LINK and
Device directories in Project tab.
24
Double-click the device (ST101) icon.
25
Check that the Device Network Node
Address entry matches the address for
the failed device. If required, key in
matching address. Click Ok to close
form.
26
In Project tab, double-click CM (pidloop)
that contains unassigned function block
for failed device.
R400
Experion PKS Series A Fieldbus Interface Module User's Guide
July 2010
8.1. Adding, Removing and Replacing Components
Action
Honeywell
8. Maintenance, Checkout, and Calibration
Result
Expands directories to show contents.
Opens Device Block Parameters form.
Address for the replacement device
matches the address assignment of the
failed device.
Opens CM in control chart.
309