Remote Control Panel - Carrier VECTOR 6500 Operation & Service Manual

3.20.2 Remote Control Panel

10
1 2
TEMP. SET POINT
DISPLAY DISPLAY
P1
NOTE:
1. TEMPERATURE DISPLAY (5C OR 5F) IS DEPENDENT ON MICROPROCESSOR CONFIGURATION
2. ENGINE LIGHT WILL NOT ILLUMINATE IN THIS APPLICATION.
The unit may be fitted with an optional remote control
panel. The panel displays compartment set point,
compartment temperature and operating modes (heat,
cool or defrost). The set point may be set and the unit
may be started and stopped using the remote panel.
This compact panels can be mounted to suit the
individual operator's preferences - in the cab, on the
front bulkhead, or in the compartment (including in the
wall itself).
62-11389
3 4
WAITING FOR COMMUNICATION WITH MICROPROCESSOR
UNIT WAS TURNED OFF VIA REMOTE CONTROL
UNIT IN DEFROST MODE
TEMPERATURE SENSOR MALFUNCTION
DISPLAYED WHEN SETTING PRE-SET SETPOINTS
1 Control panel power on LED
2 System ON/OFF key
3 Reset Button
4 Manual defrost key
5 Control panel lock LED
6 HEAT mode LED
7 COOL mode LED
9
8 Set point display
9 Up and down arrow keys
8
10 Temperature display
7
6
5
The remote control panel can be used to :
Turn the unit on or off:
S Check compartment temperature
S Check and change set point
S Initiate manual defrost
S Check mode of operation
3−32