Carrier VECTOR 6500 Operation & Service Manual page 129

Message
DOOR OPEN - LOW SPEED
ENTERING SERVICE MODE
ERROR: ENG HRS > SWITCH ON
HOURS
ERROR: HI SP HRS > TOTAL ENG
HOURS
ERROR: SBY HRS > SWITCH ON SBY
HRS
EVAC / CHARGE MODE
EXITING PRETRIP MODE
EXITING SERVICE MODE
FORCED LOW ENGINE SPEED
FUNCTION NOT CHANGED
HOUR METERS NOT CHANGED
INACTIVE ALARMS IN MEMORY
INSTALLED, REMOVE CARD XX
INSTALLING OPTION, PLEASE WAIT
INSTALL STOPPED, REINSERT CARD
INTELLI-SLEEP MODE
KEYPAD LOCKED-BATTERY TOO LOW
LIST END, = TO CLEAR ALARMS
LOADING INFO
MAIN MENU
MAX SETPOINT HAS BEEN REACHED
MICRO WILL RESET & RESTART NOW
MessageCenter MESSAGES - Continued
A refrigerated compartment door is open forcing the unit to run in
low speed.
The initial message for Service Mode.
When setting up a replacement microprocessor, incorrect hours
have been entered
The unit is in Service Mode, and the refrigeration system is ready
to be evacuated then charged with refrigerant. Refer to Section
5.2.3.
Pretrip has been aborted either by user or by a pretrip alarm.
Service Mode has been turned off and unit is returning to normal
operation.
Due to current ambient conditions and power requirements, the
engine is being set to operate in Low Speed. (See Section 4.8.3,
step 1 for more information.)
The = key was not pressed in the allotted amount of time to select
the new Functional Parameter setting. The new setting was not
stored and the old setting will be used.
Indicates that no changes have been made to the hour meters in
either the configuration or functional parameter lists.
There are inactive alarms in the microprocessor alarm list which
have not yet been cleared.
An Option PC Card has been inserted into the PC Card slot, and
the option has been installed in the microprocessor. The PC Card
may safely be removed from the slot. XX indicates the number of
option installations remaining on card.
An Option PC Card has been inserted into the PC Card slot, and
the option is being installed in the microprocessor. DO NOT RE-
MOVE THE CARD WHILE THIS MESSAGE IS BEING DIS-
PLAYED.
An Option PC Card has been inserted into the PC Card slot, and
the install process has been stopped by the PC Card not being fully
inserted in the slot, or by being removed. Remove and reinsert PC
Card to continue.
The IntelliSleep IntelliSet is active. This message alternates with
"CHANGE INTELLISET TO EXIT" at 5 second interval whether unit
is running or not
Once the battery voltage goes below 7.0 Volts for 10 seconds, all
of the keys on the keypad will be locked.
The end of the Alarm list has been reached. Pressing the = key will
clear the Alarm list.
A Configuration PC Card has been inserted into the PC Card slot,
and information from the card is being loaded into the micropro-
cessor. DO NOT REMOVE THE CARD WHILE THIS MESSAGE
IS BEING DISPLAYED.
Consists of Configuration Mode, Component Test and Service
Modes.
Maximum set point allowed by configuration settings has been
reached.
The microprocessor Program software has just been changed, or a
new configuration has been programmed into the microprocessor.
The microprocessor will turn itself off then on again (similar to a
computer reboot) in order for the changes to be effective.
Description
6−3
62-11389