Carrier VECTOR 6500 Operation & Service Manual page 67

* Displays information or setting entered in the microprocessor Configurations
+ May or may not be displayed depending on Parameter/Configuration settings
SUPPLY AIR TEMP
DELTA-T
AMBIENT AIR TEMP
DEFROST TERM TEMP 1
SUCTION LINE TEMP
EVAP OUTLET TEMP
COMP DISCHARGE TEMP
BATTERY
CURRENT DRAW (DC)
ENGINE RPM
UNIT AC CURRENT #1
UNIT AC CURRENT #2
+
FUEL LEVEL
SUCTION MOD VALVE
EXPANSION VALVE
START MODE
+
INSTALLED OPTIONS
SOFTWARE REVISION
DISPLAY SOFTWARE REV
CONTROL SERIAL #
*
TRAILER ID #
*
UNIT SERIAL #
*
UNIT MODEL #
+ HOURS TO ENGINE
MAINTENANCE
+ HOURS TO S/B MOTOR
MAINTENANCE
+ HOURS TO UNIT
MAINTENANCE
+ TIME LEFT TO PM (1-5)
62-11389
Table 3-1. Unit Data - Continued
Supply (air leaving evaporator) temperature
Supply air temperature minus return air temperature
Ambient (air entering condenser) air temperature
Defrost termination temperature
Suction line temperature at the compressor
Suction line temperature leaving the evaporator outlet
Compressor discharge temperature
Battery voltage
Battery charging or discharging amps
Engine speed
High voltage current draw on circuit #1.
High voltage current draw on circuit #2.
This is only displayed when the sensor is configured ON. % of fuel in
tank.
% open of CSMV
% open of EVXV
AUTO if the engine will start automatically
MANUAL if the engine must be started manually
This is only displayed when one or more options is configured ON. Lists
installed options. Press "=" to access the list.
Revision of the software that is operating the microprocessor
Revision of the software that is operating the display
Serial Number of the microprocessor
ID (as configured by the user)
Unit serial number
Unit model number
This is only displayed when the meter is configured ON. Number of en-
gine hours until the next programmed engine maintenance
This is only displayed when the meter is configured ON.
Number of hours until the next programmed electric standby motor main-
tenance.
This is only displayed when the meter is configured ON. Number of
switch-on hours until the next programmed general unit maintenance.
This is only displayed when one or more of the meters is configured ON.
Number of hours until the next programmed maintenance. (May display
user programmed identification.)
3−18