Carrier VECTOR 6500 Operation & Service Manual page 121

Configuration
RANGE 1 LOCK
OR
RANGE 2 LOCK
• RANGE 1 (or 2) MINIMUM
TEMPERATURE
• RANGE 1 (or 2) MAXIMUM
TEMPERATURE
MIN SET POINT
MAX SET POINT
NO A/C POWER
S/S PARAMETERS
REMOTE TEMP SENSOR 1 (or 2 or
3)
Table 5−2. Microprocessor Configurations - Continued
Selections
OFF
START-STOP
CONTINUOUS
-22°F TO 89.6°F
(-30°C to 32°C)
in 0.1°F or °C in-
crements
-22°F TO 89.6°F
(-30°C to 32°C)
in 0.1°F or °C in-
crements
-225F TO 89.6°F
(-305C to 32°C)
in 0.1°F or °C in-
crements
-22°F TO 89.65F
(-30°C to 325C)
in 0.1°F or °C in-
crements
ALARM &
SHUTDOWN
SWITCH TO EN-
GINE
TOGETHER
SEPARATE
ON / OFF
OFF = If both Range Locks are OFF, the unit will
operate normally.
If either Range 1 or Range 2 is not OFF, the unit
will operate as selected whenever the set point is
within that range
START-STOP = The unit will always operate in
Start-Stop whenever the setpoint is between the
minimum & maximum temperatures for that range
(see the following sub-configurations).
CONTINUOUS = The unit will always operate in
Continuous Run whenever the setpoint is between
the minimum & maximum temperatures for that
range (see the following sub-configurations).
Select the lowest temperature desired for this
Range.
Select the highest temperature desired for this
range.
Indicates to the microprocessor the desired minim-
um allowable set point .
Indicates to the microprocessor the desired maxim-
um allowable set point.
ALARM & SHUTDOWN = If standby power is lost
unit is to shutdown
SWITCH TO ENGINE = If standby power is lost
engine will be started.
TOGETHER = When the Minimum Run Time, Mini-
mum Off Time, Restart Temperature, Maximum Off
Time, and Override Temperatures are set in the
Functional Parameter List, the same values will be
used for both Frozen and Perishable setpoints.
SEPARATE = When the Minimum Run Time, Mini-
mum Off Time, Restart Temperature, Maximum Off
Time, and Override Temperatures are set in the
Functional Parameter List, different values may be
entered for Perishable and Frozen setpoints.
ON = A remote sensor has been added to the unit,
and connected into the wire harness.
OFF = There is no Remote Sensor (1or 2 or 3) in
this unit.
5−19
Description
62-11389