Carrier VECTOR 6500 Operation & Service Manual page 73

PARAMETER
FUNCTION
SELECTIONS
Allows user to set the number of minutes the unit will run in low speed every time the engine starts.
SCONTINUOUS OFF
1 TO 255MINS
1 MINUTE
OFF
SSTART-STOP
1 TO 255MINS
10 MINUTES
SLEEP MODE
For complete instructions on entering and setting parameters for Sleep Mode refer to Section
3.8. Press "=" to access menu.
SETTINGS
SWITCH TO
* NO S/B POWER
DIESEL
SHUT UNIT DOWN
OVERRIDE NO
REMOTE YES
SWITCH 1
SHUTDOWN
(REMS1)*
AND
OVERRIDE
REMOTE
SWITCH 2
SHUTDOWN
(REMS2)*
AND
OVERRIDE
DOOR SWITCH
SHUTDOWN
(DS)*
ENGLISH
ESPAÑOL
FRANÇAIS
LANGUAGE:
IDIOMAS:
PORTUGUÊS
LANGUE:
LINGUAGEM:
NOTE 1: This parameter can be quickly accessed by pressing and holding the Select Key for
6 seconds.
NOTE 2: If the padlock is visible when accessing language from the Functional Parameter
List, the language cannot be changed. However, when accessing the language by pressing
and holding the Select Key for 6 seconds the language can be changed even if the padlock is
displayed.
62-11389
Table 3-2 Functional Parameters - Continued
Low Speed Startup Minutes
Press "=" to access menu.
Allows user to set the number of minutes the unit will run in low speed
every time the engine starts in Continuous operation.
Allows user to set the number of minutes the unit will run in low speed
every time the engine starts in Start-Stop Operation.
*If the NO AC POWER Configuration is set to "Alarm & Shutdown" this
parameter will not display
SWITCH TO DIESEL = If the NO AC POWER Configuration is set to
the "Switch To Engine" (on power loss), setting this parameter to
"SWITCH TO DIESEL" will confirm the Configuration and the switch
will be allowed.
SHUT UNIT DOWN = If the NO AC POWER Configuration is set to
the "Switch To Engine", setting this parameter to SHUT UNIT DOWN
will override the Configuration setting and shut the unit down when
power is lost. The purpose of this setting is to temporarily override the
Configuration setting in situations where switching to engine power is
not desired.
*If the Switch is configured "Switch Not Installed", this parameter will
not display
NO = the microprocessor will respond to the switch as configured
YES = the configured action on activation of the switch will be overrid-
den and the action will be alarm only. The purpose of this setting is to
temporarily override the Configuration setting in situations where shut-
down or speed change is not desired.
ENGLISH- All information displayed in the MessageCenter will be dis-
played in English.
FRANÇAIS- All information displayed in the MessageCenter will be
displayed in French.
ESPAÑOL- All information displayed in the MessageCenter will be dis-
played in Spanish.
All information displayed in the MessageCenter will be
PORTUGUÊS -
displayed in Portuguese.
3−24
DESCRIPTION