Starting Unit With Remote Control Panel; Changing Set Point With Remote Control Panel - Carrier VECTOR 6500 Operation & Service Manual

a.Starting Unit with Remote Control Panel
1. The unit can be shutdown using either the remote panel or the unit switch panel mounted Main Power
switch. The remote panel cannot operate if the unit switch panel mounted Main Power switch is in the OFF
position.
2. In order to prevent a constant drain on the battery, the remote panel will de-energize after two hours. If the
panel is equipped with a RESET button, press the button to re-energize the panel. If the panel is not
equipped with a RESET button, the panel may be re-energized by placing the unit switch panel mounted
Main Power switch in the OFF position and then back in the desired position.
1. Place
the unit switch panel
mounted Main Power switch
in the desired position.
2. Press The SYSTEM ON/OFF
Key. The POWER Light will illu-
minate.
b. Changing Set Point With Remote Control Panel
NOTES
Press the UP or DOWN ARROW key
to increase or decrease set point.
3−33
62-11389