Recommended Transport Temperatures; Quick Glance On The Display Board; Cab Control - Carrier XARIOS X150-04 Operator's Manual

5.

RECOMMENDED TRANSPORT TEMPERATURES

Below are some general recommendations on product transport temperatures and operating modes for the
unit. These are included for reference only and should not be considered pre- -emptive of the setpoint required
by the shipper or receiver.
More detailed information can be obtained from your Carrier Transicold dealer.
Bananas
Fresh fruits and vegetables
Fresh meats and seefood
Dairy Products
Ice
Frozen fruits and vegetables
Frozen meats and seafood
Ice cream
* During delivery cycles that include frequent stops and door openings, it is recommended that the unit always
be operated in the continuous run mode to help insure product quality. It is essential to shut down the unit during
the periods when the body doors are open, in order to maintain the temperature of the cargo and keep the unit
operating correctly.
6.

QUICK GLANCE ON THE DISPLAY BOARD

Keep the fold out sheet while reading the instructions.
6.1.

Cab control

Keep the fold out sheet while reading the instructions.
This functionnal accessory simplifies all control operations. From his seat, the driver can carry out all the
control operations : shut- -down, automatic start- -up in road mode, adjusting the setpoint, defrost.
The driver can display the box temperature and see whether the setpoint is being maintained by checking the
green indicator. The indicator lights up red in the event of a malfunction. When the battery voltage is too low,
a fail- -safe system shuts down the unit. Unit restart is automatic and time- -delayed if the voltage rises to the
normal level.
1. Display
2. Standby operation LED 2 Standby operation LED
3. Road operation LED 3. Road operation LED
4. Manual defrost key
- -
5. key
62- -61177- -01
Product Set- - point Range
15_C
+4_C to +6_C +39_F to +43_F
+2_C
+2_C to +6_C +36_F to +43_F
- -20_C 15_F to 20_F
- -18_C
- -20_C - -10_F to 0_F
- -25_C
6. Set key
+ +
7 7. key k
8. OFF key 8. OFF key
9. ON key
10. Unit operation display
Green : off cycle (left half) Green : off cycle (left half)
Red : malfunction (right half)
60_F
+36_F
0_F
- -20_F
11