How To Wire For/Use Safety Function - Omron SYSDRIVE MX2 SERIES User Manual

How to Wire for/Use Safety Function

Observe the above safety standard and follow the wiring example. Be sure to use both the GS1
input and GS2 input to design a system where both GS1 input and GS2 input are turned OFF
upon actuation of the safety function.
Upon detecting an OFF state of the GS1 input or GS2 input, the Inverter actuates the safety
function and stops the output.
Reference
The safety monitor (62: EDM) turns ON when the output is cut off upon detection of an OFF state
of both the GS1 input and GS2 input signals. If the output stopped due to the safety function but
the EDM output did not turn ON, check the GS1 and GS2 input circuits and EDM detection circuit.
Parameter
No.
C003
C004
C013
C014
C021
P1/EDM Selection
C031
b145
*1.When the safety function selector switch is turned ON, this setting is applied forcibly and the selection
can no longer be changed.
*2.When the EDM function selector switch is turned ON, this setting is applied forcibly and the selection
can no longer be changed.
*3. An E37 trip occurs. In the case of a competitive External Trip (E12) setting, "E37" setting is given
priority unless at power-on.
*4.If either the GS1 or GS2 input terminal turns ON while an E37 trip is still present, safety cannot be
ensured by the safety function.
SYSDRIVE MX2 Series USER'S MANUAL (3G3MX2-Axxxx)
Function name
Multi-function 77: GS1 input (safety input 1)
Input Selection 78: GS2 input (safety input 2)
Multi-function
Input Operation 01: NC (NC contact)
Selection
Multi-function
Output Terminal 62: EDM (Safety device monitor)
Multi-function
Output Terminal
00: NO (NO contact)
P1/EDM Contact
Selection
GS Input 00: Not tripped (Cut off by hardware)
Operation
01: Tripped
Selection
5-13 Safety Function
Data
*1
*1
*1
*2
*2
*3 , *4
Default
Unit
setting
18
−
12
−
00
−
00
−
00
00 −
5-168
5