Omron SYSDRIVE MX2 SERIES User Manual page 94

4-2 Function Mode
Parameter No. Function name
C021
4
C022
C026
4-27
Monitor or data range
00: RUN (During RUN)
01: FA1 (Constant speed reached)
02: FA2 (Set frequency min. reached)
03: OL (Overload warning)
04: OD (PID excessive deviation)
05: AL (Alarm output)
06: FA3 (Meet designated frequency
Multi-function
during accel./decel.)
07: OTQ (Overtorque/Undertorque)
Output
09: UV (Signal during undervoltage)
Terminal P1/
10: TRQ (During torque limit)
EDM Selection
11: RNT (RUN time over)
12: ONT (Power on time over)
13: THM (Thermal warning)
19: BRK (Brake release)
20: BER (Brake error)
21: ZS (0Hz)
22: DSE (Excessive speed deviation)
23: POK (Position ready)
24: FA4 (Set frequency exceeded 2)
25: FA5 (Meet designated
frequency 2 during accel./decel.)
26: OL2 (Overload warning 2)
27: FVdc (Analog FV disconnection
detection)
28: FIdc (Analog FI disconnection
Multi-function
detection)
Output
31: FBV (PID FB status output)
Terminal P2
32: NDc (Communication
Selection
disconnection detection)
33: LOG1 (Logic operation output 1)
34: LOG2 (Logic operation output 2)
35: LOG3 (Logic operation output 3)
39: WAC (Capacitor life warning)
40: WAF (Cooling fan life warning signal)
41: FR (Starting contact signal)
42: OHF (Fin overheat warning)
43: LOC (Low current signal)
44: Reserved.
45: Reserved.
46: Reserved.
50: IRDY (Operation ready)
Multi-function
51: FWR (During forward operation)
Relay Output
52: RVR (During reverse operation)
53: MJA (Fatal fault signal)
(MA, MB)
54: WCFV (Window comparator FV)
Function
55: WCFI (Window comparator FI)
Selection
58: FREF (Frequency command source)
59: REF (RUN command source)
60: SETM (Motor 2 selection)
62: EDM (Safety device monitor)
63: Reserved.
no: NO (Not assigned)
Data can
Default
be set
Set data
setting
during
RUN
00
(RUN)
01 (FA1)
05 (AL)
SYSDRIVE MX2 Series USER'S MANUAL (3G3MX2-Axxxx)
Data can be
changed Unit Page
during RUN
no yes
−
no yes 5-32
no yes