Omron SYSDRIVE MX2 SERIES User Manual page 384

8-1 Inspection and Maintenance
8-1 Inspection and Maintenance
Do not change wiring, slide switches, or optional devices while power is being supplied.
Doing so may result in a serious injury due to an electric shock.
Do not remove the terminal block cover during the power supply and 10 minutes after the power
shutoff.
Doing so may result in a serious injury due to an electric shock.
Do not touch the Inverter fins, braking resistors and the motor, which become too hot during the
power supply and for some time after the power shutoff. Doing so may result in a burn.
Do not dismantle, repair or modify this product.
Doing so may result in an injury.
Maintenance and Inspection
Be sure to confirm safety before conducting maintenance, inspection or parts replacement.
The life of the capacitor depends on ambient temperatures. Refer to the diagram of product life
specified in the manual. When the capacitor stops operating at the end of the product's life, the
Inverter must be replaced.
8
Operation Stop Command
Provide a separate emergency stop switch because the STOP key on the Digital Operator is valid only
when function settings are performed.
When checking a signal during the power supply and the voltage is erroneously applied to the control
input terminals, the motor may start abruptly. Be sure to confirm safety before checking a signal.
Maintenance and Parts Replacement
The Inverter consists of many parts, and these parts must operate properly in order to make full
use of the designed functions of the Inverter. Among the electronic components, there are some
that require maintenance depending on their usage conditions. In order to keep the Inverter
operating normally over a long period of time, it is necessary to perform periodic inspections and
replace parts according to their service life.
Product Disposal
Comply with the local ordinance and regulations when disposing of the product.
8-1
WARNING
Caution
Precautions for Safe Use
Precautions for Correct Use
SYSDRIVE MX2 Series USER'S MANUAL (3G3MX2-Axxxx)