Removing A Summit X480 Series Switch - Extreme Networks Summit X150 Series Hardware Installation Manual

4 Push the latching tab to the left as you pull outward on the handle to disengage the power supply
internal connectors.
Figure 349: Removing a Summit X460 DC Power Supply
5 Carefully slide the power supply the rest of the way out of the switch.
Removing the Summit X460 Series Switch from the Rack
To remove a Summit X460 series switch from the equipment rack:
1 Verify that the power supplies have been removed from the switch.
2 Support the switch as you remove the screws that hold the switch to the rack.
3 Slide the switch out of the rack.

Removing a Summit X480 Series Switch

This section provides procedures for removing a Summit X480 series switch from a two-post or four-
post equipment rack.
Before you remove a Summit X480 series switch from the rack, remove all installed power supplies.
Removing a Summit 450 W or 550 W AC Power Supply
Summit 450 W AC power supplies are used in Summit X480 series and X670 series switches.
Summit 550 W AC power supplies are used only in Summit X670 series switches.
Caution
The power supply may be hot to the touch; wear thermal protective gloves when handling
the power supply during removal.
To remove a Summit 450 W or 550 W AC power supply:
1 Disconnect the AC power cord from the wall outlet and from the power input connector on the
power supply.
Summit Family Hardware Installation Guide
Removing a Summit Family Switch from a Rack
363