Optional Ports For The Summit X460 Series Switches - Extreme Networks Summit X150 Series Hardware Installation Manual

Figure 134: VIM2-SummitStack-V80 Module
VIM3-40G4X Versatile Interface Module
The VIM3-40G4X versatile interface module provides four unpopulated cages for QSFP+ optical
modules or QSFP+ compatible direct-attach active or passive cables.
Ports 25 and 26 can be enabled as alternate stacking ports for the Summit X480 series switch.
Each physical port can be configured to operate as a single 40-Gbps port or as four 10-Gbps ports.
When the port operates in 40-Gbps mode, you can connect the port using either a QSFP+ direct-attach
cable or an installed QSFP+ module and compatible fiber optic cable. When the port is configured to
operate in 10-Gbps mode, you must connect it using a special 1-to-4 breakout fiber optic cable.
The VIM3-40G4X module requires ExtremeXOS 15.1.2 software (or later) installed on the Summit X480
series switch.
Figure 135: VIM3-40G4X Versatile Interface Module
1 = QSFP+ port

Optional Ports for the Summit X460 Series Switches

The rear panel of all Summit X460 switches provides slots to install the following:
•
XGM3-2sf port option card
•
XGM3S-2sf option card
•
XGM3S-2xf option card
•
Summit X460 series stacking module
•
XGM3SB-4sf option card
Summit Family Hardware Installation Guide
Summit Option Cards and Versatile Interface Modules
2 = Port LEDs
147