Removing Eps Series Ac Redundant Power Supplies - Extreme Networks Summit X150 Series Hardware Installation Manual

7 Push the power supply in until the latch snaps into place.
Figure 317: Installing A Summit X650 AC Power Supply
Caution
Do not slam the power supply into the switch.
8 Connect the power cord to the power supply and to a grounded AC power outlet.
Warning
Always be sure that the source outlet is properly grounded before plugging the AC power
cord into the AC power supply.
9 If the power supply is equipped with a power cord retainer, use the retainer to secure the power
cord to the power supply.

Removing EPS Series AC Redundant Power Supplies

Removing an EPS-LD or EPS-500 Power Supply
To remove an EPS-LD or EPS-500 power supply:
1 Disconnect the AC power by removing the plug from the wall.
2 Disconnect the AC power cord from the power supply.
3 Disconnect the redundant power cord that connects the switch to the power supply.
4 Remove the mounting screws securing the power supply to the rack.
5 Slide the power supply out of the rack.
Summit Family Hardware Installation Guide
Replacing AC Power Supplies in Summit Family Switches
332