Chapter 8: Installing Optional Ports; Installing A Summit Port Option Card - Extreme Networks Summit X150 Series Hardware Installation Manual

8
Installing Optional Ports

Installing a Summit Port Option Card

Installing an Option Card in Slot B of a Summit X460 Series Switch
Installing a Versatile Interface Module in a Summit X480, X650, or X670 Series Switch
This chapter describes how to install Summit port option cards, versatile interface modules, and
stacking modules.
Note
Read the information in this chapter thoroughly before trying install or remove a Summit
option card.
Installing a Summit Port Option Card
You need the following tools and equipment to install a Summit option card:
•
ESD-preventive wrist strap
•
# 1 Phillips screwdriver
•
Straight-tip screwdriver for the XGM3-2sf option card
Caution
Be sure that proper ESD controls are in use before switch maintenance is performed. This
includes but is not limited to wrist straps that are grounded to the switch chassis and earth
grounds.
Pluggable optical modules may become very hot after prolonged use. Take care when
removing a pluggable optical module from the option card. If the pluggable optical module is
too hot to touch, disengage the module and allow it to cool before removing it completely.
Summit port option cards are not hot-swappable. Disconnect power to the switch before
installing or removing any option card. After the Summit port option card is installed in a
compatible switch, you can hot-swap the pluggable optical modules. Use only optical
modules approved by Extreme Networks.
Installing XGM and XGM2 Series Port Option Cards
All Summit XGM and XGM2 series port option cards are installed the same way. The instructions in this
section apply to all option cards for the Summit X350, X450a, and X450e series switches.
To install a Summit XGM or XGM2 series port option card:
1 Disconnect the AC power and any redundant power supply from the Summit switch.
2 Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to an
appropriate ground point on the equipment rack.
Summit Family Hardware Installation Guide 317