Vim4-40G4X Versatile Interface Module For The Summit X670 Switch - Extreme Networks Summit X150 Series Hardware Installation Manual

SummitStack
Module
XGM3SB-4sf Port Option Card
The XGM3SB-4sf option card allows you to add up to four 10-Gigabit SFP+ optical ports to Slot B on
the rear panel of the Summit X460 series switch.
These ports support synchronous Ethernet (Sync-E). The XGM3SB-4sf option card supports either SFP
+ optical modules or the SFP+ direct-attach passive copper cable.
Figure 140: XGM3SB-4sf Option Card
1 = SFP+ ports
VIM4-40G4X Versatile Interface Module for the Summit X670
Switch
The rear panel of the Summit X670 switch provides a slot for an optional VIM4-40G4X versatile
interface module.
The VIM4-40G4X module (see
provides four unpopulated cages for QSFP+ optical modules or QSFP+ compatible active or passive
cables.
Ports S3 and S4 can be enabled as native stacking ports for the Summit X670 switch. Each physical
port can be configured to operate as a single 40-Gbps port or as four 10-Gbps ports. When the port
operates in 40-Gbps mode, you can connect the port using either a QSFP+ direct-attach cable or an
installed QSFP+ module and compatible fiber optic cable. When the port is configured to operate in 10-
Gbps mode, you must connect it using a special 1-to-4 fan-out cable.
The VIM4-40G4X module requires ExtremeXOS 12.6.1 software (or later) installed on the Summit X670
switch.
Summit Family Hardware Installation Guide
Summit Option Cards and Versatile Interface Modules
SummitStack-V80
Module
2 = LEDs
Figure 141: VIM4-40G4X Versatile Interface Module on page 151)
150