Installing An Eps-600Ls External Power Module - Extreme Networks Summit X150 Series Hardware Installation Manual

Installing an EPS-600LS External Power Module

Install one, two, or three EPS-600LS power modules (model 10913) in the EPS-C chassis (Model No.
10912) to build an external redundant power system for a Summit PoE-capable switch.
A redundant power cable shipped with the EPS-C chassis provides the connection between the
external power system and the redundant power input connector on the back of the switch.
Note
An AC power cord is not provided with the EPS-600LS power module. See
Requirements for AC-Powered Switches and AC Power Supplies
selecting a power cord.
Each EPS-C chassis is shipped with a special redundant power supply cord for connection to
the Summit switch. Make sure that the EPS-C chassis is installed in the rack system before
installing an EPS-600LS unit.
Installing an EPS-C Chassis
Caution
Do not use the rack-mount brackets to suspend the EPS-C from under a table or desk, or to
attach the EPS-C unit to a wall.
The EPS-C is intended for use only with a Summit X450e-48p or X250e-48p switch. You can install the
EPS-C above or below the Summit switch.
Figure 276: EPS-C and Summit Switch
To rack-mount the EPS-C:
1 Place the EPS-C upright on a secure work surface.
2 Remove the mounting bracket kit from the packaging.
3 Attach the mounting brackets as follows:
a Place a rack-mount bracket over the mounting holes on one side of the unit.
Summit Family Hardware Installation Guide
Installing Summit External Power Supplies
for information about
Power Cord
299