Extreme Networks Summit X150 Series Hardware Installation Manual page 296

For this reason, each unit has two sets of mounting holes on each side. Extreme Networks recommends
that you position the EPS-500 unit so that the power output connectors of the EPS-500 unit are on the
same side as the external connector on the connecting switch.
The EPS-500 unit can be mounted in a rack or placed free-standing on a table.
Note
An AC power cord is not provided with the EPS-500 unit. See
AC-Powered Switches and AC Power Supplies
Rack-mount an EPS-500 Power Supply
Caution
When you install an EPS-500 in an equipment rack, make sure that the air vents are not
restricted. Allow for elevated ambient operating temperatures when the unit is installed
adjacent to other equipment. To avoid hazardous conditions due to uneven mechanical
loading, make sure that the equipment is mounted properly in the equipment rack.
Caution
Do not use the rack-mount brackets to suspend the EPS-500 from under a table or desk, or
to attach the unit to a wall.
To rack-mount each EPS-500:
1 Place the EPS-500 upright on a stable surface, with the side you want to face to the front of the
switch toward you.
2 Remove the mounting bracket kit from the packaging.
3 Attach the mounting brackets as follows:
a Place a mounting bracket over the mounting holes on one side of the EPS-500 (see
Attaching a Mounting Bracket
b Insert the provided screws and fully tighten the screws using a screwdriver.
Figure 273: Attaching a Mounting Bracket
c Repeat steps 2 and 3 on the opposite side of the EPS-500.
Summit Family Hardware Installation Guide
Installing Summit External Power Supplies
for information about selecting a power cord.
on page 296).
Power Cord Requirements for
Figure 273:
296