Extreme Networks Summit X150 Series Hardware Installation Manual page 300

b Insert the provided screws and tighten them securely.
Figure 277: Attaching the Mounting Bracket
c Repeat steps 2 and 3 for the other side of the EPS-C.
4 Slide the EPS-C into a 19-inch rack and secure it using appropriate rack-mount screws.
5 Connect the keyed end of the redundant power cord to the EPS-C (see
Redundant Power Cord
up.
The key is a plastic tab on the cable connector housing that fits into the EPS-C to ensure correct
alignment of the connector.
6 Connect the other end of the redundant power cord to the Summit X450e-48p or X250e-48p
switch (see Figure 278: Installing the Redundant Power Cord
the connector marked TOP is facing up.
Figure 278: Installing the Redundant Power Cord
Installing an EPS-600LS Power Supply
To install an EPS-600LS unit into an EPS-C:
Summit Family Hardware Installation Guide
on page 300). Verify that the side of the connector marked TOP is facing
Installing Summit External Power Supplies
Figure 278: Installing the
on page 300). Be sure that the side of
300