Extreme Networks Summit X150 Series Hardware Installation Manual page 301

1 If necessary, remove a cover plate from a slot in the EPS-C.
2 Slide the EPS-600LS into an empty slot in the EPS-C.
Caution
Be sure that empty slots in the EPS-C chassis are always covered by a cover plate when
not in use. The EPS-C is shipped with slots 2 and 3 covered and slot 1 open. Extreme
Networks recommends that you populate slot 1 with an EPS-600LS unit first, but this is
not required. You can install EPS-600LS units into any of the slots in the EPS-C. The
installation sequence does not affect the performance of the power supply units, but
empty slots must be covered at all times.
Figure 279: Installing the EPS-600LS Unit in the EPS-C Chassis
3 Slide the unit completely into the chassis until the front of the EPS-600LS is flush with the surface of
the EPS-C (see
Summit Family Hardware Installation Guide
Figure 280: Securing the EPS-600LS to the EPS-C Chassis
Installing Summit External Power Supplies
on page 302).
301