Installing A Summit Xgm3 Series Port Option Card - Extreme Networks Summit X150 Series Hardware Installation Manual

3 Remove the screws holding the filler panel over the option slot on the back of the switch (see the
figure below).
4 Remove the filler panel and set it aside.
a Save the screws for re-use.
Figure 299: Option Slot Filler Panel
5 Align the sheet metal edges on the option card with the card guides in the switch housing.
6 Carefully slide the option card into the switch housing until the connectors engage and the card is
flush with the back panel of the switch.
Figure 300: Installing a Summit Port Option Card (XGM-2xn Shown)
7 Using the screws from the cover plate, secure the option card to the back panel of the switch.
If you install only one pluggable optical module in the Summit option card, attach the appropriate cover
plate or dust cover over the remaining open optical module slot or cage.
Note
Be sure that the switch option slot always has either an installed Summit option card or a
faceplate over the opening. An open slot could divert air from the switch and cause
overheating.
For information about installing or replacing the pluggable optical modules in the Summit option card,
refer to the Extreme Networks Pluggable Interface Modules Installation Manual.

Installing a Summit XGM3 Series Port Option Card

The XGM3 series port option cards can be installed only in a Summit X460 series switch; they are not
mechanically compatible with any other Summit switch series.
To install an XGM3 series port option card:
Summit Family Hardware Installation Guide
Installing Optional Ports
318