Power Cord Requirements For Ac-Powered Switches And Ac Power Supplies; Console Connector Pinouts - Extreme Networks ExtremeSwitching 5420 Series Hardware Installation Manual

Power Cord Requirements for AC-Powered Switches
and AC Power Supplies
Table 56: Power Specifications (continued)
Power cord wall plug
Efficiency
Table 57: Environmental Specifications
Operating temperature
Storage temperature
Operating humidity
Operational shock
Power Cord Requirements for AC-Powered Switches and AC Power
Supplies
An AC power cord is not included with the AC power supply.
Power cords used with AC-powered switches or AC power supplies must meet the following
requirements:
•
The power cord must be agency-certified for the country of use.
•
The power cord must have an IEC320-C13 connector for connection to the switch or power supply.
•
The power cord must have an appropriately rated and approved wall plug applicable to the country
of installation.
•
For cords up to 6 feet (2 m) long, the wire size must be 18 AWG (.75 mm
minimum wire size is 16 AWG (1.0 mm
For details about obtaining AC power cords for use in your country, refer to
www.extremenetworks.com/product/powercords/.

Console Connector Pinouts

Table 58 describes the pinouts for a DB-9 console plug connector.
Table 58: Pinouts for the DB-9 Console Connector
Function
DCD (data carrier detect)
RXD (receive data)
TXD (transmit data)
DTR (data terminal ready)
GND (ground)
DSR (data set ready)
110 ExtremeSwitching 5420 Series Hardware Installation Guide
Refer to Power Cord Requirements for AC-Powered Switches
and AC Power Supplies on page 110
Minimum efficiency: 88% at maximum power output
0°C to 45°C (normal operation)
-40°C to 70°C
93% relative humidity, non-condensing at 30C
30 m/s 2 (3 G)
2
).
Pin Number
1
2
3
4
5
6
Technical Specifications
2
) minimum; over 6 feet, the
http://
Direction
In
In
Out
Out
-
In