Isis Authentication-Mode; Isis Circuit Type - Zte ZXR10 Command Manual

Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Related
Commands
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example

isis authentication-mode

Use this command to configure IS-ISv6 authentication mode on
the interface. Restore default with the no form of this command.
Interface configuration
isis authentication-mode {md5 | text}[level-1 | level-2]
no isis authentication-mode {md5 | text}[level-1 | level-2]
md5 | text
level-1 | level-2
The interface authentication mode is text by default.
This command is supported after platform version 4.6.02.
This example describes how to set the authentication mode on
the interface as text with the range level-1, and then restore the
default setting.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#isis authentication-mode md5 level-1
ZXR10(config-if)#no isis authentication-mode level-1
ipv6 isis password
ipv6 isis password

isis circuit type

Use this command to configure the IS-ISv6 circuit type on the
interface. Restore default with the no form of this command.
Interface configuration
isis circuit-type {level-1 | level-1-2 | level-2-only}
no isis circuit-type
level-1 | level-1-2 |
level-2-only
The interface circuit-type is level-1-2 by default.
This command is supported after platform version 4.6.02.
This example describes how to set the circuit type on some inter-
face as level-1, and then restore the default setting.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#isis circuit-type level-1
ZXR10(config-if)#no isis circuit-type
Confidential and Proprietary Information of ZTE CORPORATION
Interface authentication mode, requiered
Range where the authentication mode acts, if
there is no specification, both are valid.
Interface circuit type, required
Chapter 5 IS-ISv6 Protocol
71