Default-Metric; Ipv6 Rip Active-Interface; Ipv6 Rip Enable - Zte ZXR10 Command Manual

ZXR10 Command Manual (IPv6 Volume)
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Defaults
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
42 Confidential and Proprietary Information of ZTE CORPORATION

default-metric

Use this command to set the default metric, and use the no form
of this command to restore the default value.
Router configuration
default-metric <metric>
no default-metric
<metric>
The default value is 1.
This command is used to configure the default metric of RIPng
protocol.
This example describes how to configure the default metric value.
ZXR10(config)#ipv6 router rip
ZXR10(config-router)#default-metric 10

ipv6 rip active-interface

Use this command to configure packets which can only be sent on
some interface. Use the no form of this command to cancel the
configuration.
Interface configuration

ipv6 rip active-interface

no ipv6 rip active-interface
This command is disabled by default.
This command makes an interface on which RIPng protocol is en-
abled only send RIPng packets.
This example describes how to make an interface only send but
not receive packets.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#ipv6 rip active-interface
ipv6 rip passive-interface

ipv6 rip enable

Use this command to enable RIPng on the interface. Use the no
form of this command to disable it on the interface.
Interface configuration

ipv6 rip enable

Sets the default metric, range: 1~16