ZXR10 Command Manual (IPv6 Volume)
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
56
Confidential and Proprietary Information of ZTE CORPORATION
<cost-value>
<instance-id>
There is no configuration of cost by default.
The command is used to modify the cost value of the interface.
This example describes how to configure the interface cost value
as 100.
ZXR10(config)# interface fei_1/1
ZXR10(config-if)#ipv6 ospf cost 100 instance 5
ipv6 ospf dead-interval
Use this command to specify the dead interval of the neighbor on
the interface. Restore the default value with the no form of this
command.
Interface configuration
ipv6 ospf dead-interval <interval>[instance <instance-id>]
no ipv6 ospf dead-interval [instance <instance-id>]
<interval>
<instance-id>
For point-to-point and broadcast interfaces, the default value is 40
seconds.
For non-broadcast and point-to-multipoint interfaces, the default
value is 120 seconds.
The command is used to modify the dead interval of the neighbor
on the interface.
This example describes how to configure the dead interval of the
neighbor on the interface as 100 seconds.
ZXR10(config)# interface fei_1/1
ZXR10(config-if)#ipv6 ospf dead-interval 100 instance 5
Value of the interface cost, range: 1~65535;
the cost value of the broadcast network
interface and the point-to-point interface is
10; the default cost value of the loopback
interface is 1
OSPFv3 instance identifier
Dead interval of the neighbor on the interface
in seconds, range: 1~65535, default: 40
seconds
OSPFv3 instance identifier