Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Example
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
redistribute(BGP4+)
Use this command to redistribute the routes obtained from other
routing protocols into the BGP routing table. Cancel the redistri-
bution with the no form of this command.
Router configuration and address family configuration
redistribute <protocol>[metric <metric-value>][route-map
<map-tag>]
no redistribute <protocol>[metric][route-map]
<protocol>
metric <metric-val
ue>
route-map
<map-tag>
This command is disabled by default.
This example describes how to redistribute routes obtained by RIP
into the BGP routing table in IPv6 address family configuration
mode.
ZXR10(config)#router bgp 1
ZXR10(config-router)#address-family ipv6
ZXR10(config-router-af)#redistribute rip
reset ip bgp
Use this command to soft reset BGP sessions.
Global configuration
reset ip bgp [vrf <vrf-name>][<ipv4-address>|<ipv6-address
>|<peer-group-name>]
<ipv4-address>
<ipv6-address>
<peer-group-name>
vrf <vrf-name>
This command enables the neighbors which is already not in the
BGP session termination status. This command first disables and
then enables the BGP sessions in the active status.
This example describes how to soft reset the BGP sessions with
the neighbor 2000::1.
Confidential and Proprietary Information of ZTE CORPORATION
Protocol name: connected, static,
RIPOSPF-intOSPF-extISIS-1ISIS-2ISIS-1-2
Metric of the redistributed route, If it is not
specified, the default value will be used. The
range is 0~4294967295
Name of the route map for redistribution,
1~16 characters
IPv4 address of the neighbor
IPv6 address of the neighbor
Peer group name
VRF name, 1~16 characters
Chapter 6 BGP4+ Protocol
115