Ipv6 Pim Hello-Interval; Ipv6 Pim Join-Prune-Interval - Zte ZXR10 Command Manual

Syntax
Description
Instructions
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
<priority>
The ipv6 pim dr-priority command configures the neighbor pri-
ority used for PIM DR election. The router with the highest DR
priority on an interface becomes the PIM DR. If several routers
have the same priority, then the router with the highest IPv6 ad-
dress on the interface becomes the DR.
In the share network which connects to multicast data source, only
DR can encapsulate packets and transmit Register messages to RP.
In the share network which connects to receiver, only DR can re-
sponse the MLD join and leave messages.
show ipv6 pimsm interface
show ipv6 pimsm neighbor

ipv6 pim hello-interval

Use this command to configure the interval of transmitting Proto-
col Independent Multicast (PIM) hello messages on an interface.
Restore the default with the no form of this command.
Interface configuration
ipv6 pim hello-interval <seconds>
no ipv6 pim hello-interval
<seconds>
show ipv6 pimsm interface

ipv6 pim join-prune-interval

Use this command to configure periodic join and prune announce-
ment intervals for a specified interface. Restore the default value
with the no form of this command.
Interface configuration
ipv6 pim join-prune-interval <seconds>
no ipv6 pim join-prune-interval
<seconds>
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 7 IPv6 Multicast Protocol
An integer value to represent DR priority,
range: 0~4294967295, default: 1
Interval at which PIM hello messages are
sent, in seconds, range: 1~3600, default: 30
seconds
The join and prune announcement intervals,
in seconds, range: 10~600, default: 60
seconds
139