Default-Metric(Ospfv3) - Zte ZXR10 Command Manual

ZXR10 Command Manual (IPv6 Volume)
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
54 Confidential and Proprietary Information of ZTE CORPORATION
hello-interval
<seconds>
dead-interval
<seconds>
retransmit-interval
<seconds>
transmit-delay
<seconds>
If the specified area does not exist, it will be created automatically.
When this command is used, this area will be changed into the
transmission area.
This example describes how to configure a virtual link.
ZXR10(config)#ipv6 router ospf 1
ZXR10(config-router)#area 3 virtual-link 10.80.52.105

default-metric(OSPFv3)

Use this command to configure the default metric value of external
routes imported by OSPFv3. Use the no form of this command to
restore the default value.
Router configuration
default-metric <metric-value>
no default-metric
<metric-value>
The default metric value is 20.
This command takes effect only when the metric value of external
routes is not configured.
This example describes how to configure the default metric value
as 100.
ZXR10(config)#ipv6 router ospf 1
ZXR10(config-router)#default-metric 100
Time interval of sending HELLO packets on
the virtual link in seconds, range: 1~8192,
default: 10 seconds
Neighbor dead interval on the virtual link in
seconds, range: 1~8192, default: 40 seconds
Retransmit interval over the virtual link in
seconds, range: 1~8192, default: 5 seconds
Delay for transmitting a packet of link status
update on virtual links in seconds, range:
1~8192, default: 1 second
Sets the default metric value of the system
external routes, range: 1~16777214