Exit-Address-Family Ipv6; Hello-Padding - Zte ZXR10 Command Manual

Syntax
Description
Instructions
Example
Purpose
Command Modes
Syntax
Example
Purpose
Command Modes
Syntax
Defaults
Instructions
Example
< distance >
This command is supported after the platform version 4.6.02.
This example describes how to set the distance of IS-ISv6 routes
as 120, and then restore the default setting.
ZXR10(config)#router isis
ZXR10(config-router)#address-family ipv6
ZXR10(config-router-af)#distance 120
ZXR10(config-router-af)#no distance

exit-address-family ipv6

Use this command to exit IPv6 address family configuration mode.
IPv6 address family configuration

exit-address-family ipv6

This example describes how to exit IPv6 address family configu-
ration mode.
ZXR10(config)# router isis
ZXR10(config-router)#address-family ipv6
ZXR10(config-router-af)#exit-address-family

hello-padding

Use this command to configure Intermediate System-to-Interme-
diate System (IS-IS) hellos to be padded to the full maximum
transmission unit (MTU) size with 0 on the interface. Remove this
padding with the no form of this command.
Interface configuration
hello padding [multi-point | point-to-point]
no hello padding [multi-point | point-to-point]
The behavior of this command is enabled by default.
The platform version 4.6.02 and upgrade versions support this
command.
This example describes how to disable Intermediate System-to-
Intermediate System (IS-IS) hellos to be padded with 0 on some
interface.
ZXR10(config)#router isis
ZXR10(config-router)#hello padding point-to-point
ZXR10(config-router)#no hello padding point-to-poin
Confidential and Proprietary Information of ZTE CORPORATION
Administrative distance of IS-ISv6 routes,
range: 1~255, default: 115, it is used for the
IPv6 route calculation. The smaller it is, the
better IS-ISv6 routes are than those obtained
by other routing protocol or other routing
mode.
Chapter 5 IS-ISv6 Protocol
69