Ipv6 Ospf Priority; Ipv6 Ospf Retransmit-Interval - Zte ZXR10 Command Manual

Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
ZXR10(config-if)#ipv6 ospf network point-to-point instance-id 5
ipv6 ospf neighbor

ipv6 ospf priority

Use this command to configure the interface priority. Restore the
default interface priority with the no form of this command.
Interface configuration
ipv6 ospf priority <value>[instance-id <instance-id>]
no ipv6 ospf priority [instance-id <instance-id>]
<value>
<instance-id>
Use the command to modify the interface priority.
This example describes how to configure the priority of the inter-
face fei_1/1 as 20 .
ZXR10(config)# interface fei_1/1
ZXR10(config-if)#ipv6 ospf priority 20 instance-id 5

ipv6 ospf retransmit-interval

Use this command to configure the time interval for the interface
to retransmit the LSA. Restore the default time interval with the
no form of this command.
Interface configuration
ipv6 ospf retransmit-interval <interval>[instance-id <instan
ce-id>]
no ipv6 ospf retransmit-interval [instance-id <instance-id>]
<interval>
<instance-id>
Use the command to modify the time interval for the interface to
retransmit the LSA.
This example describes how to configure the time interval for the
interface to retransmit the LSA as 20 seconds .
ZXR10(config)# interface fei_1/1
Confidential and Proprietary Information of ZTE CORPORATION
Interface priority, range: 0~255, default: 1
OSPFv3 instance identifier, range: 0~255,
default: 0
Time interval for the interface to retransmit
the LSA in seconds, range: 1~65535, default:
5 seconds
OSPFv3 instance identifier, range: 0~255,
default: 0
Chapter 4 OSPFv3 Protocol
59