Show Ipv6 Pim Traffic - Zte ZXR10 Command Manual

Related
Commands
Purpose
Command Modes
Syntax
Instructions
If there is group option after this command, then this group (*, g)
and all routing entries related with (s, g) will be displayed.
If there are group and source address options after this command,
then the specified (s, g) routing entries will be displayed.
If there is the parameter route-count, then only the routing en-
tries statistic information will be displayed.
The command information description is shown below.
Field
SM UP
JP
Flags
RP
RPF
Local
Joined
Asserted
show ipv6 pim mroute

show ipv6 pim traffic

Use this command to display statistic information about protocol
packets received/sent by multicast PIM-SM and statistics informa-
tion about the upsent packets received.
All modes
show ipv6 pim traffic
The displayed information is described as follows:
Field
Valid PIM Datas
Valid PIM Packets
Join-Prune
Hello
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 7 IPv6 Multicast Protocol
Description
PIM-SM protocol run time
Upstream state
Flag bit
RP information, (S, G) does not have it
RPF neighbor information
Local member information on outgoing
interface
Join member information on outgoing
interface
Assert status information on outgoing
interface
Description
Number of the received/sent correct pim
packets
Number of the received/sent correct pim
protocol packets
Number of the received/sent Join-Prune
packets
Number of the received/sent hello packets
155