Ipv6 Nat V4V6 Source - Zte ZXR10 Command Manual

ZXR10 Command Manual (IPv6 Volume)
Syntax
Description
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
16 Confidential and Proprietary Information of ZTE CORPORATION
<name>
<start-ipv6>
<end-ipv6>
<prefix-length>
This command is supported after the platform version 4.6.02.
The pool is used when NAT-PT needs a dynamic mapping of an IPv6
address to translate an IPv4 address. When some IPv4 address
requires translating by some designated dynamic translation rule,
some IPv6 address will be taken out of the specified pool of IPv6
addresses to generate a translation entry.
This example describes how to set an address pool of which the
prefix length, starting IPv6 address, ending IPv6 address, name
respectively as 120, 3000::1, 3000::10, natpt-pool.
ZXR10(config)#ipv6 nat v4v6 pool natpt-pool 3000::1 3000::10
prefix-length 120

ipv6 nat v4v6 source

Use this command to configure IPv4 to IPv6 address static trans-
lation using Network Address Translation—Protocol Translation
(NAT-PT).
Global configuration
ipv6 nat v4v6 source <A.B.C.D> X:X::X:X [protocol {tcp | udp
| icmp}]
no ipv6 nat v4v6 source <A.B.C.D> X:X::X:X [protocol {tcp |
udp | icmp}]
<A.B.C.D>
X:X::X:X
udp
tcp
icmp
This command is supported after the platform version 4.6.02.
Name of the pool
Starting IPv6 address that defines the range
of IPv6 addresses in the address pool
Ending IPv6 address that defines the range of
IPv6 addresses in the address pool
Number that indicates how many bits of the
address indicate the network. Specify the
subnet of the network to which the pool
addresses belong
IPv4 network address
IPv6 network address
Designates the static address translation only
for UDP packets
Designates the static address translation only
for TCP packets
Designates the static address translation only
for ICMP packets