ZXR10 Command Manual (IPv6 Volume)
Purpose
Command Modes
Syntax
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
86
Confidential and Proprietary Information of ZTE CORPORATION
neighbor timers............................................................... 113
neighbor update-source.................................................... 113
network ......................................................................... 114
redistribute(BGP4+) ........................................................ 115
reset ip bgp .................................................................... 115
router bgp ...................................................................... 116
show bgp all neighbor ...................................................... 116
show bgp all protocol ....................................................... 117
show bgp all summary ..................................................... 118
show bgp ipv6 unicast...................................................... 119
show bgp ipv6 unicast labels ............................................. 121
show bgp ipv6 unicast neighbor(BGP4+) ............................ 121
show bgp ipv6 unicast summary(BGP4+)............................ 123
show ip as-path-access-list(BGP4+) ................................... 124
show ip bgp peer-group(BGP4+) ....................................... 125
show ip bgp protocol(BGP4+)............................................ 125
show ip community-list(BGP4+) ........................................ 126
show ip extcommunity-list(BGP4+) .................................... 127
show ip prefix-list(BGP4+)................................................ 127
timers bgp...................................................................... 128
address-family ipv6(BGP4+)
Use this command to enter IPv6 address family configuration
mode.
Use the no form of this command to restore router
configuration mode.
Router configuration
address-family ipv6
no address-family ipv6
This command is disabled by default.
This command is supported after platform version 4.6.02.
The extended BGP supports multiple address configuration mode.
This example describes how to enter IPv6 address family configu-
ration mode.
ZXR10(config)#router bgp 1
ZXR10(config-router)#address-family ipv6
ZXR10(config-router-af)#
bgp always-compare-med
Use this command to ensure the comparisons of the Multi-exit Dis-
criminator (MED) for paths from neighbors in different autonomous
systems. Disable the command with the no form of this command.
Router configuration
bgp always-compare-med
no bgp always-compare-med