Nd6 Add - Zte ZXR10 Command Manual

ZXR10 Command Manual (IPv6 Volume)
Syntax
Syntax
Description
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
26 Confidential and Proprietary Information of ZTE CORPORATION
ipv6 route X:X::X:X / <0-128>{(X:X::X:X [<interface>]) |<in
terface>}[<1-254>]
no ipv6 route X:X::X:X /<0-128>{(X:X::X:X [<interface>])
|<interface>}[<1-254>]
X:X::X:X /<0-128>
X:X::X:X
<interface>
<1-254>
This command is supported after the platform version 4.6.02.
If the next hop address of a static route is a link-local address,
there must be the name of the next hop interface in this command.
Two static routes with the same network ID and mask length are
not supported.
The next hop address of a static route can not use its own address.
If there is no information about the next hop in the no form of
this command, static routes matching destination network ID and
mask length will be deleted. If there is no such route, there will be
no tips. If there is information about the next hop in the no form
of this command, only static routes matching destination network
ID, mask length and next hop will be deleted. Otherwise, there
will be error information.
This example describes how to set a static route to 2000::0/60.
Its next hop address and administrative distance are respectively
3000::2 and 100.
ZXR10(config)#ipv6 route 2000::0/60 3000::2 100
show ipv6 route
show ipv6 route summary

nd6 add

Use this command to add a static entry in the neighbor cache list
in interface configuration mode. To delete the static entry, use the
nd6 delete or clear nd cache command.
Interface configuration
nd6 add <ipv6-address><hardware-address>
Network ID and mask length of the destination
of the static route
Next hop address
Name of the next hop interface
Administrative distance, the smaller the
value, the higher the priority of the route
corresponding to the other one with the
same destination network and mask length.
default: 1