Area Stub; Area Virtual-Link - Zte ZXR10 Command Manual

Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
ZXR10(config-router)#area 3 range 200::/64

area stub

Use this command to define an area as a stub area. Cancel the
setting with the no form of this command.
Router configuration
area <area-id> stub [no-summary]
no area <area-id> stub [no-summary]
<area-id>
no-summary
The no area <area-id> stub no-summary command is used to
allow the ABR to send the summary route information to the stub
area.
The no area <area-id> stub command is used to change the spec-
ified area from a stub area to a non-stub area.
If the specified area does not exist, it will be automatically created.
This example describes how to configure an area as the stub area.
ZXR10(config)#ipv6 router ospf 1
ZXR10(config-router)#area 3 stub

area virtual-link

Use this command to define an OSPF virtual link. Delete the spec-
ified virtual link with the no form of this command.
Router configuration
area <area-id> virtual-link <router-id>[hello-interval <secon
ds>][retransmit-interval <seconds>][transmit-delay <secon
ds>][dead-interval <seconds>]
no area <area-id> virtual-link <router-id>
<area-id>
<router-id>
Confidential and Proprietary Information of ZTE CORPORATION
Configures the area identifier, and defines
it as a decimal value (0~4294967295) or
an IP address in the dotted decimal format
(A.B.C.D)
Forbids ABR from sending the summary route
information to this stub area
Configures the area identifier, and defines
it as a decimal value (0~4294967295) or
an IP address in the dotted decimal format
(A.B.C.D)
Identifier of the peer router of the virtual link,
an IP address in the dotted decimal format
Chapter 4 OSPFv3 Protocol
53