Show Bgp Ipv6 Unicast - Zte ZXR10 Command Manual

Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example

show bgp ipv6 unicast

Use this command to display the entries in BGP IPpv6 unicast ad-
dress family routing table.
All modes
show bgp ipv6 unicast
show bgp ipv6 unicast detail <ip-address><net-mask>
<ip-address>
<net-mask>
If this command does not carry parameters, all BGP legal routes
will be displayed. If there is the network parameter the network
which matched the BGP routing table will be displayed. If there
are network number and network mask parametersall BGP routes
matching address/mask will be displayed; Use the show bgp ipv6
unicast detail command to display all detailed routes.
This example describes how to display BGP IPv6 unicast address
family legal routes.
ZXR10#show bgp ipv6 unicast
Routes of bgp:
status codes: *valid, >best,i-internal
Origin codes: i-IGP, e-EGP, ?-incomplete
Network
*>i 3ffe:1::1/64
*>i 4ffe:4::2/64
Descriptions of the displayed fields are shown below.
For BGP route
Field
Dest
Nexthop
Mertic
LocPrefL
Path
Other leading protocol route
Field
Dest
Nexthop
Confidential and Proprietary Information of ZTE CORPORATION
Network number, in the form of dotted
decimal
Network mask, in the form of dotted decimal
NextHop Metric
2.2.2.1 0
2.2.2.1 0
Description
Specific route
Next hop attribute of Update messages
Multi-exit discriminator attribute of Update
messages
Local priority attribute designated by the
imported policy
Adds origin attribute to As-path sequence in
Update messages
Description
Specific route
Route next hop
Chapter 6 BGP4+ Protocol
LocPrf Path
12345678 200 ?
12345678 200 ?
119